Volkswagen Golf Service & Repair Manual: Starter
- Assembly overview - starter (vehicles with manual gearbox)
- Assembly overview - starter, vehicles with dual clutch gearbox (DQ200–7F)
- Assembly overview - starter, vehicles with dual clutch gearbox (DQ250-6F)
- Removing and installing starter, vehicle with manual gearbox
- Removing and installing starter, vehicles with double clutch gearbox (DQ200–7F)
- Removing and installing starter, vehicles with double clutch gearbox (DQ250-6F)
Removing and installing voltage regulator, manufacturer: Valeo
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Removin ...
Assembly overview - starter (vehicles with manual gearbox)
1 -
Starter -B-
Removing and installing
→ Chapter
2 -
Double stud
Specified torque: 80 Nm
...
Other materials:
Without needing to purge refrigerant circuit of contaminants (e.g. damage in
an accident); no refrigerant has escaped and no moisture or dirt has entered
refrigerant circuit
Drain refrigerant circuit.
–
Renew restrictor. Depending on vehicle
–
Remove receiver or reservoir.
–
Clean any dirt out of receiver or reservoir.
...
Installing engine
Procedure
Engine/gearbox assembly secured to engine support T10497.
Note
Renew bolts that are tightened with specified tightening
angle.
Renew self-locking nuts and bolts ...
Tools and materials commercially available
Caution
Non-authorised tools or materials (e.g. leak
inhibitor additive) may cause damage or adversely
influence the system.
Only tools and materials a ...
