Volkswagen Golf Service & Repair Manual: Selector mechanism
Assembly overview - selector mechanism
- Assembly overview - selector mechanism, manufacturer ZF
- Moving push button to installation position in the handle
- Removing and installing selector mechanism with selector lever cable
- Removing and installing selector mechanism without selector lever cable, manufacturer ZF
- Removing and installing selector lever cable, manufacturer ZF
- Checking selector mechanism
- Checking and adjusting selector lever cable
Moving mechatronic unit for dual clutch gearbox -J743- into removal position
by hand
Note
Only if you cannot set the mechatronic unit to removal position with
the vehicle diagnostic tester, you must set the unit by hand to removal
position.
...
Assembly overview - selector mechanism, manufacturer ZF
1 -
Handle with selector cover
Do not remove handle without reason. Emergency release from position
P
→ Chapter
Removing ...
Other materials:
Upper section of the centre console
Fig. 7 Overview of the upper section of
the centre console
Key for :
Indicator lamp for the front passenger
front airbag switch-off function
Vent –
–
Infotainment system (factory-fitted)
Operating display
Radio ⇒ BookletRadio,
N ...
Removing and installing high-voltage heater (PTC) -Z115- / high-voltage
heater (PTC) -J848
Special tools and workshop equipment
required
Commercially available Torx socket bit “TS30H” with hole in
front face
Hose clamps, up to 25 mm -3094-
Engine bung set -VAS 6122- ...
Removing and installing air intake duct
Note
The illustration shows a left-hand drive vehicle. The
removal and installation procedure is identical for both
versions.
Removing
–
Remove dash pa ...
