Volkswagen Golf Service & Repair Manual: Checking selector mechanism

Volkswagen Golf Service & Repair Manual / 7- speed dual clutch gearbox 0CW / Gearbox mechanism, operation, contruction, diff / Selector mechanism / Checking selector mechanism

The starter must not operate in the selector lever positions “R”, “D” and “S” and in the Tiptronic position.

On right-hand drive vehicles, the starter must operate in selector lever positions “P” and “N” only when the button in the selector lever handle is not pressed.

Over 5 km/h:

When the selector lever is shifted to “N”, the selector lever lock solenoid must not lock the selector lever. Selector lever can be shifted back into a driving range.

Under 5 km/h:

When the selector lever is shifted to “N”, the selector lever lock solenoid must lock the selector lever only after ca 1 second. Selector lever cannot be shifted out of “N” position until brake pedal is depressed.

Selector lever in “P” position and ignition switched on

Brake pedal not depressed:

Selector lever is locked and cannot be shifted out of “P” position when the button is pressed. Solenoid for selector lever lock blocks selector lever.

Brake pedal is depressed:

Solenoid for selector lever lock releases selector lever. It is possible to shift into a driving gear. Slowly shift selector lever from “P” through to “S”, checking whether selector lever position in dash panel insert corresponds to selector lever position.

Selector lever in “N” position and ignition switched on

Brake pedal not depressed:

Selector lever is locked and cannot be shifted out of “N” position with the push button pressed. Solenoid for selector lever lock blocks selector lever.

Brake pedal is depressed:

Solenoid for selector lever lock releases selector lever. It is possible to shift into a driving gear.

Selector lever in position “Tiptronic”

Shift selector lever into Tiptronic gate.

The illumination of the “D” symbol in the selector mechanism cover must go out. “+” and “-” symbols must light up.

When the selector lever is shifted into the Tiptronic gate, the selector lever position display in the dash panel insert must change from “P R N D S” to “6 5 4 3 2 1”.

Ignition and light switched on

The respective symbol in the shift mechanism cover lights up.

Selector lever position display

Simultaneous illumination of all selector lever position display segments indicates gearbox emergency running mode.

Removing and installing selector lever cable, manufacturer ZF

Special tools and workshop equipment required Removal lever -80 - 200- Removing ...

Checking and adjusting selector lever cable

Brief description Selector lever cable must be removed from gearbox so that its ease of movement can be checked. Put removed end down so it doe ...

Other materials:

Removing and installing centre console retainer, securing bracket and insulation for selector mechanism, e-Golf only
Special tools and workshop equipment required Torque wrench -V.A.G 1783- Removing Front bracket Note Removal and ...

Opening and closing the bonnet
Fig. 190 In the footwell on the driver side: lever for releasing the bonnet Fig. 191 Release lever for opening the bonnet above the radiator grille First read and observe the introductory information and safety warnings Opening the bonnet Ensure that the windscreen wiper arms are pos ...

Air conditioner compressor without magnetic clutch, with elastic drive coupling
The air conditioner compressor is driven directly by the power steering vane pump. There is an overload protection on the drive shaft of the air conditioner compressor, which shears in the event of the air conditioner compressor seizing, ...