Volkswagen Golf Service & Repair Manual: Lettering and emblems
- Dimensions - lettering on rear lid
- Dimensions - lettering on rear lid, “GTI/GTD”
- Dimensions – “e-Golf” lettering on rear lid
- Dimensions – lettering on rear lid, “R-Line”
- Dimensions – lettering on wing
- Dimensions – lettering on wing, “R”
- Removing and installing manufacturer emblem
- Removing and installing model designation on radiator grille
- Removing and installing emblem with model designation, “R-Line”
- Removing and installing emblem with model designation, “R”
- Removing and installing emblems at rear
Removing and installing rear wheel housing liner
Special tools and workshop equipment
required
Torque wre ...
Dimensions - lettering on rear lid
Note
When fitting the lettering, observe the fitting notes
→ Anchor.
1 -
Lettering
Model designation.
2 - ...
Other materials:
Emptying fuel tank with fuel tank more than 3/4
full, engine code CWVA
Special tools and workshop equipment required
Removal wedge -3409-
Wrench -T10202-
Torque wrench -V.A.G 1332-
Fuel extractor -VAS 5190-
Fuel extractor -VAS 5190 A- for E 85 fuel (not shown).
&nb ...
Balancing wheel, balancing wheel on stationary wheel balancer
Before you start balancing the wheels, the following
requirements must be met.
Tyre pressure must be OK.
Tread must not be worn on one side. Tread depth should be at
least 4 mm.
T ...
Adjusting the steering wheel position
Fig. 50 Adjusting the steering wheel position
mechanically
First read and observe the introductory information
and safety warnings Adjust the steering wheel position before setting off
and only when the vehicle is stationary.
Push down the lever .
Adjust the steering wheel s ...
