Volkswagen Golf Service & Repair Manual: Dimensions – lettering on rear lid, “R-Line”
Note
| When fitting the lettering, observe the fitting notes → Anchor. |
| 1 - | Lettering |
- Model designation
| 2 - | Height dimension |
- 73 ± 1 mm, from upper edge of lettering to tail light.
| 3 - | Horizontal dimension |
- 50 ± 1 mm, from outer edge of rear lid to lettering
Dimensions – “e-Golf” lettering on rear lid
Note
When fitting the lettering, observe the fitting notes
→ Anchor.
1 -
Lettering
Model designation
2 -
...
Dimensions – lettering on wing
Note
The dimensions shown here for “GTI” as an example are valid for all
emblems.
1 -
Emblem
Variations in appearance possible dependin ...
Other materials:
Removing and installing wheel housing trim, saloon
Note
Removal and installation are described for the left
vehicle side. Follow same instructions for the right side as
appropriate.
Special tools and workshop equipment
required
...
Removing and installing brake caliper
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Brake pedal depressor -V.A.G 1869/2-
& ...
Wheel change, installation requirements
Warming cold tyres to minimum installation temperature
Note
This instruction also applies to ultra-high performance
tyres (height/width ratio smaller than/same as 45 % and speed
symbol greater than/same as V).
...
