Volkswagen Golf Service & Repair Manual: Removing and installing rear wheel housing liner
| Special tools and workshop equipment
required |
|
|
|
| |
|
Torque wrench -V.A.G 1783- |
Note
-
| |
Removal and installation are described for the rear left
wheel housing liner only. The right side is similar. |
-
| |
The removal and installation procedures may have to be
modified slightly depending on model variants. |
| – |
Remove wheel
→ Running gear, axles, steering; Rep. gr.44. |
| – |
Pull rear wheel housing liner -1- out
of wheel housing. |
| Removing and installing sill panel cover
→ Anchor |
Note
| Check spreader nuts for damage, and renew them if necessary
→ Item. |
| – |
Insert rear wheel housing liner -1- in
wheel housing without kinking the liner. |
| |
Bolts
→ Chapter „Assembly overview - rear wheel housing liner“. |
Note
Minor differences may be encountered in respect of front wheel
housing liner, depending on vehicle model.
Only the left side is shown. The ...
Other materials:
Schematic diagram - coolant hoses, Golf GTE
Note
Currently, only the auxiliary heater function is available.
At the moment the auxiliary heater is not intended to be
operated as a supplementary heater. In vehicles with a
high-voltage system, the high-voltage heater (PTC) -Z115- is
...
Removing and installing dash panel insert trim
Special tools and workshop equipment
required
Removal wedge -3409
Removing
–
Remove side vent on driver side
→ ...
Measurement location
Note
The vehicle shown in the illustration may differ from the actual
vehicle.
1 -
Volkswagen logo
Laser pointer aligned to centre of Volkswagen logo
2 -
Wheel centre mounting -VAS 6350/1-
...
© 2016-2026 Copyright www.vwgolf.org
Assembly overview - rear wheel housing liner