Volkswagen Golf Service & Repair Manual: Drive shaft
- Assembly overview - drive shaft
- Removing and installing drive shaft
- Dismantling and assembling drive shaft
- Loosening and tightening threaded connections of drive shaft
- Checking outer constant velocity joint
- Checking inner constant velocity joint
Repairing trailing arm
Special tools and workshop equipment required
Tube for wheel bearing -3345-
Assembly tool -3346-
Thrust plate -VW 402-
...
Assembly overview - drive shaft
1 -
Outer constant velocity joint
Renew only as complete unit
Removing
→ Fig..
Installing: drive onto shaft ...
Other materials:
Removing and installing lock carrier – petrol/diesel
Note
The lock carrier is a safety-relevant component. For this reason, the
lock carrier must only be repaired at the points indicated.
In the event of damage, renew lock carrier
For vehicles with adaptive cruise control unit -J428-, the adaptive
cruise control unit -J428- must be adjus ...
Removing and installing luggage compartment aerial for entry and start
system -R137-
Special tools and workshop equipment
required
Release lever -80 - 200-
Removing
–
Remove rear seat bench
→ General body repair ...
Assembly overview - oil filter/oil pressure switch
1 -
Oil filter
Remove and install with oil filter tool -3417-.
Before installing, lightly coat seal with clean engine oil.
20 Nm
See note
→ Anchor
2 -
Oil pre ...
