Volkswagen Golf Service & Repair Manual: Cylinder head

Removing and installing toothed belt, engine codes CHPA, CZDA

Special tools and workshop equipment required Torque wrench -VAS 6583- Counterhold -T10172- with adapter -T10172/1- Locking pin -T10340- ...

Assembly overview - cylinder head

  Note The camshafts must not be removed individually. In the event of repair, the camshaft housing must be renewed complete ...

Other materials:

Diagonal washout
Diagonal washout on a tyre Diagonal washout runs at an angle of approx. 45° to the direction of rotation. It usually occurs at one point only, but can also occur at several points around the circumference of the tyre. ...

Assembly overview - control units, RHD vehicles
1 -  Bracket For onboard supply control unit -J519- Removing and installing → Chapter 2 -  Onboard supply control unit -J519- Removing and installing → Chapter ...

Removing and installing evaporator
  Note The illustration shows a left-hand drive vehicle. The removal and installation procedure is identical for both versions. Removing –  Observe instructions when working on refrigerant circu ...