Volkswagen Golf Service & Repair Manual: Brake servo and brake master cylinder
- Assembly overview - brake servo/brake master cylinder, LHD vehicles
- Assembly overview - brake servo/brake master cylinder, RHD vehicles
- Removing and installing brake light switch, LHD vehicles
- Removing and installing brake light switch, RHD vehicles
- Removing and installing brake servo, LHD vehicles
- Removing and installing brake servo, RHD vehicles with diesel engine
- Removing and installing brake servo for vehicles with 1.2 l and 1.4 l petrol engines
- Removing and installing brake master cylinder, LHD vehicles
- Removing and installing brake master cylinder, RHD vehicles
Removing and installing protective cap
Special tools and workshop equipment
required
Removal wedge -3409-
...
Assembly overview - brake servo/brake master cylinder, LHD vehicles
Note
Only use new brake fluid conforming to VW standard (VW 501 14).
1 -
Self-locking ...
Other materials:
New wheels and tyres
First read and observe the introductory information
and safety warnings New tyres
Drive particularly carefully for the first 600 km with new tyres as the
tyres have to be run in. Tyres that have not been run in have reduced
grip and braking effect .
All four wheels must ...
Engine preheating
Fig. 131 The front left of the bumper:
connection for engine preheating ②
First read and observe the introductory information
and safety warnings In engine preheating mode, the engine coolant is heated
slowly using a heating element while the vehicle is stationary. To do so, the cables
...
If the refrigerant circuit was completely empty
Remove defective part.
–
Remove air conditioner compressor.
–
Remove oil drain screw from air conditioner compressor.
Note
To speed up the draining of the refri ...
