Volkswagen Golf Service & Repair Manual: Subframe
- Assembly overview - subframe
- Removing and installing subframe without steering rack, except for e-Golf
- Removing and installing subframe with steering rack, LHD vehicles, except for e-Golf
- Removing and installing subframe with steering rack, RHD vehicles, except for e-Golf
- Repairing subframe
- Removing and installing anti-roll bar
- Removing and installing coupling rod
- Fixing position of subframe
Front axle
Overview of fitting locations - front axle
I -
→ Chapter „Subframe“
II -
→ Chapter „Suspension strut, upp ...
Assembly overview - subframe
1 -
Anti-roll bar with rubber bush
Removing and installing
→ Chapter
2 -
Nut
When tightening, cou ...
Other materials:
Removing and installing covers for auxiliary heater control unit -J364
Removing
–
Switch off electrical consumers.
–
Switch off auxiliary and supplementary heater and switch off
ignition.
–
Remove auxiliary heater
→ ...
Assembly overview - belt pulley, Denso air conditioner compressor
1 -
Bolt
Qty. 3.
4.5 Nm
2 -
Sealing cap
3 -
Nut
25 Nm
–
To unfasten and tighten the hexagon nut, hold the pulley in position
with ...
Tread depth and wear indicators
Fig. 202 Tyre tread: wear indicators
First read and observe the introductory information
and safety warnings Tread depth
Difficult driving situations demand the deepest possible tread depth for the
tyres and the same tread depth for the tyres on the front and rear axles. This applies
in ...
