Volkswagen Golf Service & Repair Manual: Removing and installing parking aid control unit -J446-, left-hand drive
vehicle
 Note
| When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
→ Vehicle
diagnostic tester. |
| – |
Remove trim under dash panel
→ General body repairs, interior; Rep. gr.68. |
|
|
|
| – |
Disconnect connectors -1 and 2-. |
|
|
|
| – |
To do so, press locking detent -1-,
swing retainer in -direction of arrow-
and pull off connector. |
| – |
Disengage retaining tab -arrow-
and remove control unit -3-
downwards from retainer. |
| Installation is carried out in the reverse sequence. |
|
|
|
1 -
Electrical connector
2 -
Spreader clip
3 -
Rear parking aid warning buzzer -H15-
Removing and inst ...
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
&# ...
Other materials:
Assembly overview - steering column switch module, with electronic ignition
lock
1 -
Starter button -E378-
Overview of fitting locations
→ Chapter
2 -
Steering column electronics control unit -J527-
With airbag coil connector and return ring with slip ring -F138-
...
Rear brakes
Assembly overview - rear brakes:
Note
Use the brake filling and bleeding equipment -VAS 5234- to
draw off brake fluid from the brake fluid reservoir.
Before removing a brake caliper or disconnecting ...
Removing and installing injectors
Special tools and workshop equipment
required
Tool set for FSI engines -T10133 C- with -T10133/16 A- and
-T10133/19-
Removing
Risk of functional impair ...
© 2016-2026 Copyright www.vwgolf.org
Assembly overview - rear parking aid, RHD vehicles
Removing and installing parking aid control unit -J446-, RHD vehicle