Assembly overview - drive shaft, triple roller joint AAR3300i
1 -
Bolt
Renew after removing
Loosening and tightening
→ Chapter
Before fitting, clean the threads in the CV joint using a thread
tap.
200 Nm +180°
2 - ...
Lowering rear axle, multi-link suspension, front-wheel drive, except for
e-Golf
Special tools and workshop equipment required
Assembly tool -3301-
Assembly tool -3346-
Torque wrench -V.A.G 1332-
Engine and gearbox jack -V.A.G 1383 A-
Lower subframe ...
Setting vehicle to initial position for wheel alignment
If measured values are outside specified tolerances, this
may be because the vehicle is inclined.
Right-hand drive vehicles or e.g. vehicles with an automatic
gearbox may lean to one side slightly.
This is due to the ins ...