Volkswagen Golf Service & Repair Manual: Axle beam

Removing and installing rear axle, multi-link suspension, four-wheel drive

Special tools and workshop equipment required Torque wrench -V.A.G 1332- Engine and gearbox jack -V.A.G 1383 A- Tensioning strap -T10038 ...

Assembly overview - axle beam

1 -  Cover 2 -  Bolt Renew after removing 50 Nm +45° 3 -  Bolt ...

Other materials:

Assembly overview - belt pulley, Sanden air conditioner compressor
1 -  Nut 25 Nm   Note In order to protect the thread of the air conditioner compressor drive shaft an additional plastic cap is fitted (not shown in illustration). –  To unfasten and tighten the hex ...

Removing and installing charge pressure positioner -V465-
Removing     –  Switch off ignition. –  Disconnect electrical connector -1-. –  Remove securing clip -2-. –&n ...

Removing and installing floor covering
Removing –  Remove front seats → Chapter. –  Remove rear bench seat → Chapter. –  Remove sill panel mouldings → Chapter ...