Volkswagen Golf Service & Repair Manual: Other controlling and regulating components
- Removing and installing sunlight penetration photosensor -G107-
- Function of air quality sensor -G238-
- Removing and installing ambient temperature sensor -G17-
- Removing and installing humidity sender for air conditioning system -G260-
- Removing and installing left vent temperature sender -G150
- Removing and installing right vent temperature sender -G151
- Removing and installing footwell vent temperature sender -G192
Removing and installing operating and display unit, air conditioning system
with electric/manual controls and Climatronic
Special tools and workshop equipment
required
Removal wedge -3409-
Note
...
Removing and installing sunlight penetration photosensor -G107-
Special tools and workshop equipment
required
Removal wedge -3409-
Removing
...
Other materials:
Removing and installing control unit for fuel tank leak detection -J909-
Removing
Fitting location
→ Item:
–
Release and pull off connector -arrow-
on control unit for fuel tank leak detection -J909--1-.
...
Removing and installing heater and air conditioning unit
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331/- (5…50 Nm)
Hose clamps up to 25 mm -3094-
...
Wheel alignment procedure
Always adhere to the following procedure!
Note
The vehicle must always be in unladen condition when
measuring wheel alignment
→ Chapter.
–
T ...
