VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing humidity sender for air conditioning system -G260-

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Other controlling and regulating components / Removing and installing humidity sender for air conditioning system -G260-

The humidity sender for air conditioning system -G260- and the light/rain sensor -G397- form one component and are installed depending on vehicle equipment.
–  Removal and installation procedure is described in → Electrical system; Rep. gr.92.
  Note
Diagnosis is carried out via onboard supply control unit -J519-.
   
Removing and installing ambient temperature sensor -G17-
Removing –  Remove radiator grille → General body repairs, exterior; Rep. gr.66.     ...

Removing and installing left vent temperature sender -G150
Special tools and workshop equipment required Vehicle diagnostic tester Removing   Note ...

Other materials:

Introduction
This chapter contains information on the following subjects:  → Displays    → Radar sensor    → Operating the area monitoring system (Front Assist)    → Temporarily switch off the area monitoring system (Front Assist) in the following situations     ...

Removing and installing steering column electronics control unit -J527-, Kostal
  Note Airbag coil connector and return ring with slip ring -F138- is integrated in steering column electronics control unit -J527-. When renewing the control unit, select “Renew” function for the respec ...

Removing and installing seat trim on sill side, electrically adjustable seat
  Note Removal and installation are described for the left vehicle side. Follow same instructions for the right side as appropriate. Special tools and workshop equipment required     ...

© 2016-2026 Copyright www.vwgolf.org