Volkswagen Golf Service & Repair Manual: Removing and installing ambient temperature sensor -G17-
| – |
Remove radiator grille
→ General body repairs, exterior; Rep. gr.66. |
|
|
|
| – |
Remove ambient temperature sensor -G17--1-
from bracket -arrow-. |
| – |
Remove ambient temperature sensor -G17- upwards. |
| – |
Disconnect electrical connector. |
 Note
| Ensure electrical wiring connector is properly seated to
prevent ingress of water (spray water). |
| – |
Install in reverse order. |
| Assembly overview - radiator grille
→ General body repairs, exterior; Rep. gr.66. |
|
|
|
The air quality sensor detects noxious substances in the
ambient air (primarily petrol and/or diesel fumes).
The Climatronic control unit -J255 ...
The humidity sender for air conditioning system -G260- and
the light/rain sensor -G397- form one component and are
installed depending on vehicle equipment.
...
Other materials:
Removing and installing intake manifold
Special tools and workshop equipment
required
Release tool -T10527-
Release tool -T10527/1-
Removing
–
Remove air filter housing
→ Chapte ...
Operating ParkPilot
Fig. 148 ParkPilot ultrasound sensors around
the vehicle, A: in the front bumper, B: in the rear bumper
Fig. 149 In the lower section of the centre
console: button for switching the ParkPilot on and off
First read and observe the introductory information
and safety warnings The ParkPilot ...
Hot air blower, 220 V / 50 Hz -VAS 1978/14-
Caution
When shrink-fitting, take care not to damage any
other wiring, plastic parts or insulating material with
the hot air blower.
Observe the operating instructions of the hot ai ...
© 2016-2026 Copyright www.vwgolf.org
Function of air quality sensor -G238-
Removing and installing humidity sender for air conditioning system -G260-