To open the rear trunk, ensure Model X is in Park, then do one of the following:
CAUTION: Before opening the liftgate in an enclosed area (such as a garage), ensure the opening height of the liftgate is properly adjusted to avoid low-hanging ceilings or objects (see Adjusting Liftgate Opening Height).
Model X must be unlocked or detect a key before you can use the switch to open the liftgate.
The instrument panel informs you when a door or trunk is open.
To stop a liftgate while it is moving, single-click the rear trunk button on the key fob. Then, when you double- click the rear trunk button, it moves again, but in the opposite direction (provided it was not almost entirely open or closed when you stopped it). For example, if you single-click to stop the liftgate while opening, when you double-click, it closes.
NOTE: In emergency situations, you can override an open or close command by grasping the liftgate to stop it in place.
If Model X detects a low ceiling (for example, in a garage), it opens the liftgate (and falcon wing doors) to a lower height, even if no obstacle is detected. You can override this height by manually lifting it higher. When doing so, the touchscreen prompts you to choose if you always want the trunk to open to this higher position at this location, and saves your choice. If you choose to do so, the next time you open the liftgate at this location, Model X opens it to the saved height.
WARNING: Before opening or closing the liftgate, check the surrounding area (for people and objects). Although the liftgate can detect obstacles, it cannot detect all objects at all times. Do not rely on the liftgate to sense an obstruction when opening or closing. You must proactively monitor the liftgate to ensure that it does not come into contact with a person or object. Failure to do so may result in damage or injury.
Displaying Tire Pressures
Display tire pressures on the touchscreen by touching
Controls > Service. The pressure of each tire displays in
the visualization of your Model X, in addition to what
time your tire pressures were last measured. You can
choose whether you want to display tire pressures using
Bar or PSI by to ...
Removing and installing exhaust camshaft oil seal, pulley end, engine codes
CPTA, CHPA, CZEA, CZDA
Special tools and workshop equipment
required
Assembly tool -T10478 B-
Removing
–
Detach toothed belt from camshafts
→ Chapter ...
Run-flat tyres, PAX, checking
When checking a tyre, look out especially for the following
criteria:
Surface erosion or ripples on the inner side (inflation
pressure was too low or not sufficient for the load)
...