Diesel particulate filter
Practical tipsAssembly overview - drive shaft, constant velocity joint VL107
1 -
Bolt
Renew after removing
Loosening and tightening
→ Chapter
Before fitting, clean the threads in the CV joint using a thread
tap.
200 Nm +180°
2 - ...
Removing and installing speed sensor on rear axle -G44-/-G46-, vehicles with
four-wheel drive
Note
Removal and installation is described for the rear left
speed sensor. Removal and installation of the rear right speed
sensor is analogous.
Removing
–
Raise vehicle.
&nbs ...
Warning lamp
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Fault in the alternator.
Proceed to a qualified workshop. The electrical system
should be checked.
Switch off all elec ...