Tesla Model X 2015-2023 Owner's Manual: Low Voltage Power Socket
Your Model X has a power socket located in the center console's rear compartment. To access the low voltage socket, open the front compartment of the center console.
The power socket is suitable for accessories requiring up to 12A continuous draw (16A peak).
NOTE: Power is available whenever the vehicle is considered "awake". The vehicle may be awake for many reasons. For example, when using features such as Summon, or when features such as Preconditioning, Cabin Overheat Protection, Keep Climate On, Dog Mode, Camp Mode, Sentry Mode, etc. are enabled. The vehicle is also awake whenever the low voltage battery is being charged or is in use, during high voltage charging, when the vehicle is communicating with the mobile app, etc. Leaving an accessory plugged in does not deplete the low voltage battery.
WARNING: The power socket and an accessory's connector can become hot.
WARNING: To prevent excessive interference with the vehicle's electronics, Tesla recommends that you do not plug any non-Tesla accessories, including power inverters, into the low voltage power socket. However, if you do use a non-Tesla accessory and notice any malfunctions or unexpected behavior, such as indicator lights, alert messages, or excessive heat from the accessory, unplug the accessory from the low voltage power socket immediately.
NOTE: A power inverter plugged into the low voltage power socket must support 16V DC input to function.
CAUTION: Do not attempt to jump start Model X using the low voltage power socket. Doing so can result in damage.
Wireless Phone Chargers
Wireless phone chargers are integrated into both the
front and rear consoles, each providing up to 15W of
power to charge Qi-enabled phones. Simply place your
phone on the charger. Your device may ...
Coat Hangers
Your Model X has a coat hanger on each side of the
vehicle above the rear window in the second row, next to
the reading light. Push the coat hanger to release it.
Push it again to retract it.
Acti ...
Other materials:
Removing automatic distance control unit from and installing on adapter
frame, variant 2
Removing
–
Remove adaptive cruise control unit -J428-
→ Chapter.
–
Detach fasteners -1- on both
sides in direction of arrow -A-.
...
Fitting control unit to hydraulic unit
Special tools and workshop equipment
required
ESD workplace -VAS 6613-
Torque screwdriver -V.A.G 1624-
Torx bit T25
Note
...
Adjusting Liftgate Opening Height
You can adjust the opening height of the liftgate to
make it easier to reach or to avoid low-hanging ceilings
or objects (for example, a garage door or light):
1. Open the trunk, then manually lower or raise the
liftgate to the desired opening height.
2. Press and hold the button on the undersid ...
