First read and observe the introductory information
and safety warnings
Safety certificates, stickers and plates showing important vehicle operation information are factory-fitted in the engine compartment and on certain parts such as the tank flap, front passenger sun visor, the driver door pillar or in the luggage compartment floor.
Safety certificate
There is a safety certificate on the door pillar of the driver door which states that all necessary safety standards and specifications from the transport safety authorities of the particular country were met at the time of production. The month and year of production and the chassis number may also be listed.
High voltage warning sticker
There is a sticker near the bonnet lock showing a warning about the high voltage in the vehicle's electrical system. The vehicle's ignition system fulfils the requirements of standards that include Canadian standard ICES-002.
Introduction
Using the vehicle in other countries and continentsSpecial pliers with insert
The special pliers without insert -VAS 1978/1- with insert
for special pliers -VAS 1978/2- is part of the wiring harness
repair set -VAS 1978- and is used to crimp connectors during
wiring harness repairs.
...
Changing headlights over from driving on right to driving on left (gas
discharge headlights)
If a right-hand drive vehicle is driven in a left-hand drive
country, or vice versa, the headlights must be converted. This
is necessary in order to avoid dazzling oncoming traffic with
the asymmetric low beam headlights.
Note
...
Introduction
This chapter contains information on the following subjects:
→ Drink holders in the front centre console
→ Drink holders in the rear centre armrest
→ Drink holder in the rear side trim
Bottle holder
Bottle holders are located in the open stowage areas of t ...