Volkswagen Golf Service & Repair Manual: Removing and installing onboard supply control unit -J519-, LHD vehicles

Volkswagen Golf Service & Repair Manual / Electrical system / Wiring / Control units / Removing and installing onboard supply control unit -J519-, LHD vehicles

Note

When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode → Vehicle diagnostic tester.

Removing

–	Switch off ignition.

–	Remove ignition key, if inserted.

–	Remove footwell cover on driver side → General body repairs, interior; Rep. gr.68.

–	Remove lower A-pillar trim → General body repairs, interior; Rep. gr.70.

–	Remove foot rest → General body repairs, interior; Rep. gr.70.

–	Unplug electrical connectors -1, 2, 3-.

Removing and installing onboard supply control unit -J519-, LHD vehicles

–	Press locking detent -1- to disconnect connectors.

–	Swing retainer in -direction of arrow- and pull off connector.

Removing and installing onboard supply control unit -J519-, LHD vehicles

–	Release retaining springs -arrow-, swivel onboard supply control unit -4- out of bracket -5- and remove downwards.

Installing

Installation is carried out in the reverse sequence.

Removing and installing onboard supply control unit -J519-, LHD vehicles

Assembly overview - data bus diagnostic interface

1 - Electrical connector For data bus diagnostic interface -J533- 2 - Data bus diagnostic interface -J533- Remov ...

Removing and installing onboard supply control unit -J519-, RHD vehicles

Note When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode &# ...

Other materials:

Removing and installing ambient temperature sensor -G17-
Removing – Remove radiator grille → General body repairs, exterior; Rep. gr.66. – Remove ambient temperature sensor -G17--1- from bracke ...

Using the selection menu in the instrument cluster
Fig. 16 Vehicles without a multifunction steering wheel: button ① on the windscreen wiper lever for confirming menu points, and rocker switch ② for changing menus and information displays Fig. 17 Right-hand side of the multifunction steering wheel: controls for using the menus and inform ...

Installing dual clutch
Special tools and workshop equipment required Support device -T10323- -T10356/5- from assembly tool -T10356- &nb ...