Volkswagen Golf Service & Repair Manual: Silicone remover

Volkswagen Golf Service & Repair Manual / General information, paint / Genuine products / Cleaning agents / Silicone remover

Designation:

Aqueous silicone remover -LSW 019 000 A5-

Silicone remover -LVM 020 000 A5-

Slow-drying silicone remover -LVM 020 100 A5-

Issued 02.2012

Product description - silicone remover -LSW 019 000 A5-

The silicone remover -LSW 019 000 A5- is an aqueous cleaner with no special labelling requirements, containing a small proportion of organic solvents and special cleaning additives.

Product description - silicone remover -LVM 020 000 A5- and slow-drying silicone remover -LVM 020 100 A5-

Silicone remover -LVM 020 000 A5- is a quick-evaporating mixture. Slow-drying silicone remover -LVM 020 100 A5- is a mixture of slow-evaporating organic solvents. Both are used primarily to remove oil and grease residues.

Technical data sheet

Application

The above-named silicone removers are used for cleaning sanded old or factory finishes, and surfaces coated with primer and surfacer which has been subsequently sanded, before these are treated further.

Application

Apply silicone remover using a spray bottle or a clean non-woven cloth.

Dry the surface with a dry non-woven cloth before the silicone remover evaporates.

Allow cleaned surfaces to dry completely or blow dry before recoating.

Note

Allow cleaned surface to dry completely before recoating.

Do not allow silicone remover to dry on the surface.

The product is not suitable for cleaning spray guns or tools.

Always use a clean cloth, and be sure to renew it early enough if dirty or worn out.

Heavily soiled parts must be cleaned twice.

Silicone remover -LSW 019 000 A5- is not suitable for removing release agent residues from UP-GF or other plastic surfaces.

Personal protective equipment:

Adhere to the safety data sheet.

Wear personal protective equipment during application.

Technical data - silicone remover -LSW 019 000 A5-

Silicone remover

Flash point:	Above +23 °C
VOC value: 2004/42/IIB(a)(200)200	The EU limit value for this product (product category IIB.b) in ready-to-spray form is max. 200 g/l of volatile organic compounds. The VOC content of this product in ready-to-spray form is max. 200 g/l.

Technical data - silicone remover -LVM 020 000 A5-

Flash point:	Above +4 °C
VOC value: 2004/42/IIB(a)(850)770	The EU limit value for this product (product category IIB.b) in ready-to-spray form is max. 850 g/l of volatile organic compounds. The VOC content of this product in ready-to-spray form is max. 750 g/l.

Technical data - slow-drying silicone remover -LVM 020 100 A5-

Flash point:	Above +26 °C
VOC value: 2004/42/IIB(a)(850)770	The EU limit value for this product (product category IIB.b) in ready-to-spray form is max. 850 g/l of volatile organic compounds. The VOC content of this product in ready-to-spray form is max. 770 g/l.

Storage

The guaranteed shelf life is 60 months from date of production. May be used until the date stated on the label at latest if stored in sealed original containers at +20 °C.

Silicone remover

Cleaning agents

...

Cleaner for plastics

Designation: Cleaner for plastics -D 195 850 A1- Issued 04.2009 Product description ...

Other materials:

Removing and installing tail light bulb -M2-/-M4-
Note Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way. Removing – Turn light switch to “0” position. ...

Removing and installing accelerator module -GX2-
Removing – Fold floor covering -1- forwards in -direction of arrow-. – Release and pull off connector -2- ...

Temporarily switch off the area monitoring system (Front Assist) in the following situations
First read and observe the introductory information and safety warnings The area monitoring system (Front Assist) should be switched off in the following situations due to system limitations : If the vehicle is being towed. If the vehicle is on a rolling road test bed. If t ...