Volkswagen Golf Service & Repair Manual: Cleaner for plastics
| Cleaner for plastics -D 195 850 A1- |
| The cleaner for plastics -D 195 850 A1- is a liquid
universal cleaner and thinner/reducer based on aromate-free
benzines with a low n-hexane content. This product contains no
chlorinated hydrocarbons, and does not corrode paint when used
briefly. |
| The cleaner for plastics -D 195 850 A1- is mostly used to
degrease and clean substrates prior to application of adhesives
or sealants. |
| Thorough cleaning of the surfaces to be bonded is essential
for proper adhesion, with particular emphasis on removing dust,
oil and grease. |
| Depending on the base material of the products listed above,
the cleaner may also be used to remove impurities, protruding
excess material or underseals. |
| In many applications, the cleaner for plastics -D 195 850
A1- can also be used as a thinner/reducer for certain adhesives,
sealants and coating compounds. Note that these products are not
usually diluted for application. Dilution with thinner/reducer
is indicated only for certain procedures requiring a thinner
consistency. |
 Note
| Before using, read the safety measures and recommendations
in the safety data sheet. |
| Even for products which are not required by law to be
labelled, the usual safety measures for chemical products must
be observed. |
| The cleaner for plastics -D 195 850 A1- is applied either
with a brush or a non-woven cleaning cloth, depending on the
degree of soiling and the size/shape of the parts being cleaned. |
| To prevent the contents of the original container from being
soiled, the cleaner should either be poured onto the cleaning
cloth (do not hold the cloth against the container's mouth and
then pour), or the required amount should be transferred to
another container (tin can, etc.). |
| Pour out only the amount required for cleaning, then close
the original container immediately. |
| The cleaned surfaces should be allowed to dry completely
(depending on circumstances 2 - 10 minues) before the adhesive
or sealant is applied. |
| While application of compressed air can accelerate the
drying process, under unfavourable conditions oil in the
pneumatic lines might destroy the results of the cleaning
process. |
| If the substrate has an open-pore texture, at least 30
minutes should be allowed to elapse after cleaning. When
cleaning residual material from sections that have been cut for
removal (e.g. when installing permanently located glass panes,
etc.) always observe the application instructions for the
corresponding materials. |
|
|
|
| Colour |
Water-bright, transparent |
| Odour |
Petrol |
Designation:
Aqueous silicone remover -LSW 019 000 A5-
Silicone remover -LVM 020 000 A5-
Sl ...
Designation:
Cleaner for plastics, antistatic -LVM 001 001 A2-
Note
Information on preparing and applying the c ...
Other materials:
Wheel allocation
6 J x 15
6 J x 15
Note
Always observe the allocation of wheels and tyres to the respective
engines, which are listed in the overview table.
Explanation of information on
wheels:
→ Wheels and Tyres Guide - General informatio ...
Roll-back function for the electric windows
First read and observe the introductory information
and safety warnings The roll-back function for the electric windows can reduce
the risk of injuries when the windows are closing . If the one-touch closing function
for a window does not work because it is stiff or is being obstructed, t ...
Condenser
The condenser transfers heat from the compressed refrigerant
gas to the surrounding air.
This allows the refrigerant gas to condense into liquid
form.
...
© 2016-2026 Copyright www.vwgolf.org
Silicone remover
Cleaner for plastics, antistatic