Volkswagen Golf Service & Repair Manual: Senders and sensors
- Removing and installing fuel gauge sender -G-, vehicles with front-wheel drive
- Removing and installing fuel gauge sender -G-, vehicles with four-wheel drive
- Removing and installing fuel gauge sender 2 -G169
- Removing and installing tank pressure sensor -G400
- Removing and installing control unit for fuel tank leak detection -J909-
Removing and installing fuel line for auxiliary/supplementary heater
Removing
–
Observe safety precautions
→ Chapter.
–
Observe rules for cleanliness
...
Removing and installing fuel gauge sender -G-, vehicles with front-wheel
drive
Removing
–
Remove fuel delivery unit
→ Chapter.
–
Note colour assignment of cables -1- ...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Displays  
→ Radar sensor  
→ Operating the area monitoring system (Front Assist)  
→ Temporarily switch off the area monitoring system (Front Assist) in the
following situations  
â ...
Assembly overview - oil filter/oil pressure switch
1 -
Oil filter
Remove and install with oil filter tool -3417-.
Before installing, lightly coat seal with clean engine oil.
20 Nm
See note
→ Anchor
2 -
Oil pre ...
Removing and installing evaporator
Note
The illustration shows a left-hand drive vehicle. The
removal and installation procedure is identical for both
versions.
Removing
–
Observe instructions when working on refrigerant circu ...
