|
|
Masking areas, rear body
Seam seals, front bodyRemoving and installing fresh air/recirculated air, air flow flap control
motor -V425-, RHD vehicles
Special tools and workshop equipment
required
Vehicle diagnostic tester
Note
The control motor has end stops with integrated limit
switches instead of a potentiometer.
First ca ...
Removing and installing dash panel insert trim
Special tools and workshop equipment
required
Removal wedge -3409
Removing
–
Remove side vent on driver side
→ ...
Adjusting the steering wheel position
Fig. 50 Adjusting the steering wheel position
mechanically
First read and observe the introductory information
and safety warnings Adjust the steering wheel position before setting off
and only when the vehicle is stationary.
Push down the lever .
Adjust the steering wheel s ...