Volkswagen Golf Service & Repair Manual: Removing and installing rear senders
| – |
Remove rear wheel housing liner
→ General body repairs, exterior; Rep. gr.66. |
|
|
|
| – |
Press both locking lugs in direction of arrow
-A- while at the same time pressing
in sender -1- as far as stop. |
| – |
Disconnect electrical connector -2-. |
| Install in the reverse order of removal, observing the
following: |
 Note
| When inserting the sender in the sender retainer, make sure
that the isolation ring (black silicone ring) is seated
correctly on the sender head. |
| Both locking lugs of sender retainer must audibly engage
when installing the sender. |
|
|
|
Removing
–
Remove wheel housing liner
→ General body repairs, exterior; Rep. gr.66.
...
Other materials:
Correct sitting position
Fig. 41 There must be a distance of at
least 25 cm between the driver and the steering wheel The distance to the dash panel
must be at least 10 cm in the knee area
Fig. 42 Correct seat belt routing and head
restraint adjustment
First read and observe the introductory information
and safe ...
Removing and installing crash bar
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331
Removing
–
Remove knee airbag with igniter
...
Assembly overview - bumper cover
Note
Minor differences may be encountered in respect of bumper cover,
depending on vehicle model.
1 -
Bumper cover
Material PP/EPDM
Removing and installing
→ Chapter
2 -
Guide bracket
Lef ...
© 2016-2026 Copyright www.vwgolf.org
Removing and installing front senders