Volkswagen Golf Service & Repair Manual: Assembly overview - bumper cover
Note| Minor differences may be encountered in respect of bumper cover, depending on vehicle model. |
| 1 - | Bumper cover |
- Material PP/EPDM
- Removing and installing → Chapter
| 2 - | Guide bracket |
- Left and right.
- Different versions, allocation → Electronic Parts Catalogue “ETKA”
| 3 - | Guide bracket |
- For tail light on left and right
- Different versions, allocation → Electronic Parts Catalogue “ETKA”
| 4 - | Centre guide profile |
| 5 - | Bolt |
- Left and right
- Points upwards
- Bolted to side panel.
- 2.0 Nm
| 6 - | Bolt |
- Qty. 3 on each side
- Bolted to wheel housing liner
- 2 Nm
| 7 - | Spreader rivet |
- Qty. 4
Rear bumper
...
Assembly overview - guides for bumper cover
Volkswagen R GmbH, optional equipment, “R Line” and “R”
Note
Different versions. ...
Other materials:
Removing and installing aerial amplifier for mobile telephone -R86-
Removing
–
Switch off ignition and all electrical consumers, and remove
ignition key.
–
Remove luggage compartment side trim panel (right-side) just
enough so that the aerial amplifier for mob ...
Removing and installing speed sensors on front axle -G45-/-G47
Note
Removal and installation is described for the front left
speed sensor. Removal and installation of the front right speed
sensor is analogous.
Removing
–
Raise vehicle.
&n ...
Removing and installing bracket for roof grab handle
Note
Removal and installation is described for the left front
bracket for roof grab handle. Follow same instructions for the
remaining brackets for roof grab handle as appropriate.
Special tools and workshop equipment
requ ...
