Volkswagen Golf Service & Repair Manual: Removing and installing earth wire with battery monitor control unit -J367-, vehicles without high-voltage system
|
|
|
|
|
|
|
Removing and installing battery tray
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Removin ...
Removing and installing earth wire with battery monitor control unit -J367-,
vehicles with high-voltage system
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Removin ...
Other materials:
Removing and installing bracket for parking aid control unit -J446-/park
assist steering control unit -J791-, LHD vehicles
Special tools and workshop equipment
required
Feeler gauge
Removing
–
If fitted, remove parking aid control unit/park assist
steering control unit
→ Chapter.
...
Removing and installing speed sensor on rear axle -G44-/-G46-, vehicles with
four-wheel drive
Note
Removal and installation is described for the rear left
speed sensor. Removal and installation of the rear right speed
sensor is analogous.
Removing
–
Raise vehicle.
&nbs ...
Notes on repairs to airbag and belt tensioner wiring
In addition to the general notes on repairs to wiring
harnesses, the following instructions must be observed on how to
repair wiring in airbag and belt tensioner systems:
WARNING
Airbag a ...
