Volkswagen Golf Service & Repair Manual: Removing and installing control motor sender for VARILIS headlight
-G695-/-G696-
 Note
| Control motor sender for left VARILIS headlight -G695- and
control motor sender for right VARILIS headlight -G696- are only
fitted on gas discharge headlights. |
| The control motor sender for VARILIS headlight is located in
the headlight housing and cannot be renewed separately in the
event of a fault. |
| – |
Removing and installing headlights
→ Chapter. |
|
|
|
| Removing and installing control motor for
VARILIS headlight -V446-/-V447- |
Note
| Control motor for left VARILIS headlight -V446- and control
motor for right VARILIS headlight -V447- are only fitted on gas
discharge headlights. |
| The control motor for VARILIS headlight is located in the
headlight housing and cannot be renewed separately in the event
of a fault. |
| – |
Removing and installing headlights
→ Chapter. |
|
|
|
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
...
Note
Left swivel module position sensor -G474- and right swivel
module position sensor -G475- are only fitted on gas discharge
headlights.
...
Other materials:
Removing and installing side defroster vent
Note
Removal and installation is described for the side defroster
vent on driver side. Follow same instructions for the front
passenger side as appropriate.
Special tools and workshop equipment
required
&nb ...
Removing and installing pendulum support
Remove noise insulation
→ General body repairs, exterior; Rep. gr.66.
–
Unscrew bolts -1, 2 and 3-, and
remove pendulum support.
Installi ...
Wear in middle of tyre
This wear pattern is found on the driven wheels of
high-performance vehicles that are frequently driven long
distances at high speeds.
At high speeds, centrifugal forces cause the tyre diameter
to increase more in the middle of the tread ...
© 2016-2026 Copyright www.vwgolf.org
Removing and installing output module 1 for left LED headlight -A31-/-A27-
Removing and installing swivel module position sensor -G474-/-G475-