Volkswagen Golf Service & Repair Manual: Removing and installing swivel module position sensor -G474-/-G475-
Note
| Left swivel module position sensor -G474- and right swivel
module position sensor -G475- are only fitted on gas discharge
headlights. |
| The swivel module position sensor is located in the
headlight housing and cannot be renewed separately in the event
of a fault. |
| – |
Removing and installing headlights
→ Chapter. |
|
|
|
| Removing and installing dynamic cornering
light control motor-V318-/-V319- |
Note
| Left dynamic cornering light control motor -V318- and right
dynamic cornering light control motor -V319- are only fitted on
gas discharge headlights. |
| The dynamic cornering light control motor is located in the
headlight housing and cannot be renewed separately in the event
of a fault. |
| – |
Removing and installing headlights
→ Chapter. |
|
|
|
Note
Control motor sender for left VARILIS headlight -G695- and
control motor sender for right VARILIS headlight -G696- are only
fitted on gas di ...
Assembly overview - fog lights, Golf
1 -
Fog lights
Different versions. Refer to
→ Electronic Parts Catalogue.
Removing and ...
Other materials:
Removing and installing cover cap, for lock cylinder
Removing and installing cover cap, for
lock cylinder
Note
When removing lock cylinder cover cap, the screwdriver should
not be turned and the screwdriver should not be used as a lever.
The lock cylinder and cover cap for lock cylin ...
Diagonal washout
Diagonal washout on a tyre
Diagonal washout runs at an angle of approx. 45° to the
direction of rotation.
It usually occurs at one point only, but can also occur at
several points around the circumference of the tyre.
...
Conducting a road test before balancing wheels
If a customer brings a vehicle to the workshop complaining
about “vibration”, a road test is essential prior to balancing
the wheels.
This will give you information about the nature of the
vibration.
...
© 2016-2026 Copyright www.vwgolf.org
