Volkswagen Golf Service & Repair Manual: Without needing to purge refrigerant circuit of contaminants (e.g. damage in an accident); no refrigerant has escaped and no moisture or dirt has entered refrigerant circuit

Volkswagen Golf Service & Repair Manual / Air conditioning system with refrigerant R134a / Renewing components / Renewing receiver or reservoir, and restrictor / Without needing to purge refrigerant circuit of contaminants (e.g. damage in an accident); no refrigerant has escaped and no moisture or dirt has entered refrigerant circuit

Drain refrigerant circuit.

–	Renew restrictor. Depending on vehicle

–	Remove receiver or reservoir.

–	Clean any dirt out of receiver or reservoir.

–	Weigh receiver or reservoir that was removed.

Note

Fill enough refrigerant oil into the new reservoir or collector so that it has the same weight as the container which was removed.

Install new receiver or reservoir.

–	Assemble refrigerant circuit, evacuate and charge.

After purging refrigerant circuit of contaminants, e.g. due to moisture intrusion (because refrigerant circuit has stood open for a length of time) or due to dirt

The reservoir or receiver or cartridge of the dryer bag need not be renewed under the following circumstances: After an accident in which there ...

Testing equipment and tools

List of test equipment, tools and materials Note This list is an overview of the test equipment, tools and materials necessary for professional repairs to t ...

Other materials:

Removing and installing control unit for electronic steering column lock -J764-
Note When renewing control unit, select Renewal function for respective control unit in “Guided fault finding” or “Guided functions” using → Vehicle diagnostic tester. Special tools and workshop equipmen ...

Assembly overview - park assist steering, RHD vehicles
1 - Rear park assist steering senders Rear left park assist steering sender -G716- Rear right park assist steering sender -G717- Removing and installing → Chapter 2 - Park assist s ...

Removing and installing ignition key withdrawal lock solenoid -N376-
Removing – Remove lower steering column trim → General body repairs, interior; Rep. gr.68. – Release retaining clip -arrow A-, and pull ...