Volkswagen Golf Service & Repair Manual: Overview of fitting locations - components not located in passenger
compartment, Golf Variant RHD
| 1 - |
Exhaust ventilation for passenger compartment |
| Removing and installing
→ Chapter |
| Removing and installing
→ Chapter |
| 3 - |
Cover for fresh air intake duct |
| Removing and installing
→ Chapter |
| 4 - |
Ambient temperature sensor -G17- |
| Removing and installing
→ Chapter |
1 -
Exhaust ventilation for passenger compartment
Checking
→ Chapter
Removing and installing
→ Chapter
...
1 -
Footwell vent on driver side
Removing and installing
→ Chapter
Assembly overview
→ Chapter.
...
Other materials:
Removing and installing gas strut
Removing
–
Open and support bonnet.
WARNING
Proceed with care if gas strut is reused. Spring clip must
not be levered completely out of ball socket, as it will
otherwise be damaged. Gas strut will spring ou ...
Hot air blower, 220 V / 50 Hz -VAS 1978/14-
Caution
When shrink-fitting, take care not to damage any
other wiring, plastic parts or insulating material with
the hot air blower.
Observe the operating instructions of the hot ai ...
Balancing wheel, balancing wheel on stationary wheel balancer
Before you start balancing the wheels, the following
requirements must be met.
Tyre pressure must be OK.
Tread must not be worn on one side. Tread depth should be at
least 4 mm.
T ...
© 2016-2024 Copyright www.vwgolf.org
Overview of fitting locations - components not located in passenger
compartment, Golf Variant LHD
Overview of fitting locations - components inside of front passenger
compartment, LHD vehicles