Volkswagen Golf Owners Manual: Wheel cover
Fig. 220 Removing the wheel covers
First read and observe the introductory information
and safety warningsRemoving the wheel covers
- Take the box spanner and wire hook from the vehicle toolkit.
- Insert the wire hook into one of the holes in the wheel cover.
- Push the box spanner through the wire hook and remove the wheel cover in the direction of the arrow.
Fitting the wheel covers
Before fitting the wheel cover, the anti-theft wheel bolt must be screwed into position or â‘¢. Otherwise, it will not be possible to fit the wheel cover.
The wheel covers must be pushed on to the rims with the hole for the valve aligned with the valve . When fitting the wheel cover, ensure that it engages securely on the entire circumference.
Centre cover
Fig. 218 Removing the centre covers by
pulling
Fig. 219 Removing the centre covers by
turning
First read and observe the introductory information
and safety warningsThe centre cover can be r ...
Wheel bolt caps
Fig. 221 Removing the wheel bolt caps
First read and observe the introductory information
and safety warnings
Take the wire hook from the vehicle toolkit.
Insert the hook through the open ...
Other materials:
Removing and installing centre console trim in footwell
Note
Removal and installation is described for the centre console
trim in footwell on driver side. Follow same instructions for
the front passenger side as appropriate.
Special tools and workshop equipment
required
...
Turn signal and main beam lever
Fig. 81 Turn signal and main beam lever
First read and observe the introductory information
and safety warnings Move the lever into the required position:
Right turn signal  . With ignition switched
off move from central position for right parking light   .
Left turn signal †...
Removing and installing engine speed sender -G28-
Special tools and workshop equipment
required
Socket AF 4 mm -T10370-
Removing
–
Remove noise insulation
→ General body repair ...
