VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing onboard supply control unit -J519-, RHD vehicles

Volkswagen Golf Service & Repair Manual / Electrical system / Wiring / Control units / Removing and installing onboard supply control unit -J519-, RHD vehicles

  Note
When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode → Vehicle diagnostic tester.
Removing
–  Switch off ignition.
–  Remove ignition key, if inserted.
–  Remove glove compartment → General body repairs, Interior; Rep. gr.68.
   
–  Disconnect connectors -1, 2 and 3-.
 

Removing and installing onboard supply control unit -J519-, RHD vehicles

–  Press locking detent -1- to disconnect connectors.
–  Swing retainer in -direction of arrow- and pull off connector.
 

Removing and installing onboard supply control unit -J519-, RHD vehicles

–  If present, remove guide -2-. To do so, release fasteners on guide in direction of arrow -A-.
–  Remove guide -2- from onboard supply control unit -J519--1- in direction of arrow -B-.
 

Removing and installing onboard supply control unit -J519-, RHD vehicles

–  Release retaining spring at top -2- in direction of arrow -A-.
–  Pull onboard supply control unit -J519--1- towards rear -arrow B- out of bracket.
Installing
Installation is carried out in the reverse sequence.
 

Removing and installing onboard supply control unit -J519-, RHD vehicles

Removing and installing onboard supply control unit -J519-, LHD vehicles
  Note When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode &# ...

Removing and installing data bus diagnostic interface -J533-
  Note When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode &# ...

Other materials:

Removing and installing brake pedal
It is not possible to remove the brake pedal separately. –  To be able to remove it, pedal cluster with mounting bracket must be removed first → Chapter.   Note Removing brake pedal w ...

Assembly overview - fire extinguisher
1 -  Bracket Removing –  Remove bracket -4-. –  Remove seat cover and padding from seat pan → Chapter.   WARNING Risk of eye injury. Wear ey ...

Retrofitting two-way radios
First read and observe the introductory information and safety warnings You will need an external aerial to use a two-way radio in the vehicle. Any retrofit installation of electrical or electronic equipment in the vehicle will affect its vehicle type approval. Under certain circumstances, ...

© 2016-2025 Copyright www.vwgolf.org