Brake master cylinder and brake servo
| Brake master cylinder, depending on engine type | Diameter in mm | 23.81 or 25.4 | |||
| Brake servo (LHD), depending on engine type | Diameter in inches | 10 or 11 | |||
| Brake servo (RHD) | Diameter in inches | 7 / 8 | |||
Rear brakes
Front brakesBalancing wheel, checking radial and lateral run-out of wheels and tyres
Before you start balancing the wheels, the following
requirements must be met.
Tyre pressure must be OK.
Tread must not be worn on one side. Tread depth should be at
least 4 mm.
T ...
Charging battery with battery charger -VAS 5903
WARNING
Danger of injury! Observe warning notices and safety
regulations
→ Chapter!
WARNING
It is not permissible ...
Removing and installing mounting bracket
Special tools and workshop equipment
required
Removing
Note
Removal and installation are only described for the left
door handle bracket. The right side is similar.
...