VW Golf manuals

Volkswagen Golf Service & Repair Manual: Rules for cleanliness for working on the auxiliary heater and the fuel system

Volkswagen Golf Service & Repair Manual / Auxiliary heater / Technical data / General notes / Rules for cleanliness for working on the auxiliary heater and the fuel system

Thoroughly clean all connections and adjacent areas before disconnecting.
Place parts that have been removed on a clean surface and cover. Do not use fluffy cloths!
Carefully cover or seal opened components if the repair cannot be carried out immediately.
Install clean parts only; remove replacement parts from their packages only immediately before installing them. Do not use any parts which have not been stored in their packaging (e.g. in a tool box).
If the fuel system is open:
–  Do not work with compressed air.
–  Do not move the vehicle.
–  Do not start the engine.
–  Switch on auxiliary heater.
Notes for vehicles with start-stop system
Observe the safety precautions for vehicles with a Start/Stop system → Chapter. The following abort conditions deactivate the ...

Identification plates
There are different types of identification plates. When the auxiliary heater is replaced, check the type plate and the duplicate plate and replace a ...

Other materials:

Removing and installing Valeo heat exchanger, RHD vehicles
Special tools and workshop equipment required     Drip tray for workshop hoist -VAS 6208-   Hose clamps up to 25 mm -3094- ...

Removing and installing floor covering
Removing –  Remove front seats → Chapter. –  Remove rear bench seat → Chapter. –  Remove sill panel mouldings → Chapter ...

Removing and installing camshaft housing
Removing –  Remove coolant pump → Chapter. –  Remove air filter housing → Chapter. –  Remove ignition coils → Chapter. ...

© 2016-2025 Copyright www.vwgolf.org