Volkswagen Golf Service & Repair Manual: Notes for vehicles with start-stop system

Volkswagen Golf Service & Repair Manual / Auxiliary heater / Technical data / General notes / Notes for vehicles with start-stop system

Observe the safety precautions for vehicles with a Start/Stop system → Chapter.

The following abort conditions deactivate the start-stop-function:

The Start/Stop system has been switched off via the start-stop mode button.

The charge status of the battery -A- is insufficient to restart the engine (starting voltage prediction).

The defrost function is active.

The windscreen heater function is active.

The temperature set on the operating and display unit varies by more than 8°C from the actual interior temperature.

The engine speed is greater than 1200 rpm.

The alternator -C- is defective, i.e. belt broken.

Coolant temperature is not within specifications of 25 °C - 100 °C.

Blower speed increase by more than 4 stages.

Refer to → No.426 for full description.

Starting conditions for auxiliary heater, supplementary heater mode

Terminal 15 (ignition) on Engine speed > 600 rpm Coolant temperature < 72 °C Ambient ...

Rules for cleanliness for working on the auxiliary heater and the fuel system

Thoroughly clean all connections and adjacent areas before disconnecting. Place parts that have been removed on a clean surface and cover ...

Other materials:

Removing and installing damper weight for refrigerant line, low-pressure side
Special tools and workshop equipment required Torque wrench -V.A.G 1331/- (5…50 Nm) Removing – Observe safety precautions when working in the ...

Removing and installing air filter housing
Removing – Detach air hose -2-. – Lift air cleaner housing -1- off ball studs. – Release hose clips -3- and -4- and ...

Removing and installing heat shield for centre exhaust system
Note The removal and installation procedures may have to be modified slightly depending on engine fitted. Removing – Removing rear exhaust system → Rep. gr.26. – Loosen lock washers -2-. ...