Leaks or internal damage (e.g. noises or lack of power)
After purging refrigerant circuit of contaminants, e.g. due to moisture
intrusion (because refrigerant circuit has stood open for a length of time) or
due to dirtRemoving and installing Bowden cable
Removing
WARNING
It is not permissible to loosen bolts other than
those specified.
Also, it is not permissible to perform any repair
work other than described ...
Moving mechatronic unit for dual clutch gearbox -J743- into removal position
by hand
Note
Only if you cannot set the mechatronic unit to removal position with
the vehicle diagnostic tester, you must set the unit by hand to removal
position.
Sometimes, the mechatronic unit cannot be removed. In this case, the
gear actuator for 6th gear ...
Introduction
This chapter contains information on the following subjects:
→ Preparation for changing a wheel
→ Wheel bolts
→ Lifting the vehicle with the jack
→ Changing a wheel
→ After changing a wheel
Some models are delivered without a factory-fitted jack or bo ...