Volkswagen Golf Owners Manual: Changing a wheel

Volkswagen Golf Owners Manual / If and when / Practical tips / Changing a wheel / Changing a wheel

Fig. 226 Changing a wheel: removing the wheel bolts with the screwdriver handle

First read and observe the introductory information and safety warnings

Removing the wheel

Read the checklist.

Loosen the wheel bolts.

Jack up the vehicle.

Using the hexagonal socket in the screwdriver handle , completely unscrew the loosened wheel bolts and place them on a clean surface.

Remove the wheel.

Fitting the spare wheel or temporary spare wheel

Note any specific tyre running direction .

Position the spare wheel / temporary spare wheel.

Insert the anti-theft wheel bolt using the adapter at position or ③ and tighten it slightly in a clockwise direction.

Screw in all the other wheel bolts in a clockwise direction and use the hexagonal socket in the screwdriver handle to tighten them gently.

Lower the vehicle with the jack.

Use the box spanner to tighten all the wheel bolts securely in a clockwise direction . Do not tighten the bolts in clockwise or anticlockwise sequence. Tighten them in diagonal sequence.

Fit the cover caps, centre covers or wheel covers.

WARNING

Incorrect torque or incorrect use of wheel bolts can lead to a loss of control of the vehicle, cause accidents and serious injuries.

Always keep all wheel bolts and threads in the wheel hubs clean and free from oil and grease. The wheel bolts must be easy to turn and be tightened to the specified torque.

The hexagonal socket in the screwdriver handle should only be used for turning wheel bolts, not use for loosening or tightening them.

Checklist

To ensure your own safety and the safety of your passengers, observe the following actions in the specified order : Find a firm and level surface suitable for lifting the vehicle. Swit ...

After changing a wheel

First read and observe the introductory information and safety warnings Clean the tools as necessary and place them back in the foam rubber holder in the luggage compartment. Stow the spa ...

Other materials:

Warning and indicator lamps
First read and observe the introductory information and safety warnings Lit up Possible cause Solution Electromechanical steering not functioning. The steering should be checked by a qualified workshop as soon as possible. ...

Renewing bonded rubber bush for wheel bearing housing, front-wheel drive
Special tools and workshop equipment required Assembly tool -3301- Assembly tool -3346- Assembly tool -3350- Assembly tool -T10356- Carrier -3390- Torque wrench -V.A.G 1332- &nb ...

Assembly overview - speed sensor on rear axle, front-wheel drive
1 - ABS speed sensor Clean inside surface of hole before inserting sensor Coat inside surface with high-temperature paste -G 052 112 A3- Removing and installing → Chapter 2 - Bolt ...