VW Golf manuals

Volkswagen Golf Service & Repair Manual: Removing and installing mirror adjustment unit

   

 
Special tools and workshop equipment required
   
   

Torque wrench -V.A.G 1783-
Torque wrench -V.A.G 1783-

  Note
The removal and installation sequence is only for the left adjustment unit with motor. The right side is similar.

Removing and installing mirror adjustment unit

Removing
–  Remove mirror glass → Chapter.
–  Unscrew bolts -3- (qty. 3) and remove adjustment unit -1- from mirror mounting.
–  Swivel adjustment unit together with motor -1- to the side and pull off connector -2-.
 
Installing
–  Connect connector -2- to adjustment unit -1-.
–  Place adjustment unit -1- on mirror mounting and fix in place by tightening bolts -3- (qty. 3).
–  Install mirror glass → Chapter „Removing and installing mirror glass“.
Specified torques
  Bolts → Item
    Removing and installing mirror glass
      Special tools and workshop equipment required       Note Removal and i ...

    Removing and installing mirror cover
        Note Removal and installation are described only for the left mirror cover. The right side is similar. Removing –&nbs ...

    Other materials:

    Refrigerant circuit with restrictor and reservoir
    Arrows show the direction of refrigerant flow. A- low-pressure side of the refrigerant circuit. B- high-pressure side of the refrigerant circuit.         Component Overall state of the re ...

    Removing and installing temperature flap control motor - V68-, RHD vehicles
    Heater and air conditioning system with electric/manual controls Special tools and workshop equipment required Vehicle diagnostic tester Removing –  Switch ...

    Run-flat tyres, PAX, checking
    When checking a tyre, look out especially for the following criteria: Surface erosion or ripples on the inner side (inflation pressure was too low or not sufficient for the load)     ...

    © 2016-2023 Copyright www.vwgolf.org