Volkswagen Golf Service & Repair Manual: Removing and installing ESP sensor unit -G419-

Volkswagen Golf Service & Repair Manual / Brake system (hybrid) / ABS, ADR, TCS, EDL, ESP / Sensors / Removing and installing ESP sensor unit -G419-

The lateral acceleration sender -G200-, the yaw rate sender -G202- and the longitudinal acceleration sender -G251- are installed together with the control unit for electromechanical parking brake -J540- in the ABS control unit -J104-.

The components cannot be renewed individually.

–	Removing and installing ABS control unit -J104- → Chapter.

Removing and installing steering angle sender -G85-

The steering angle sender -G85- is installed in steering rack.

The steering angle sender -G85- cannot be renewed separately.

–	Removing and installing steering → Running gear, axles, steering; Rep. gr.48.

Removing and installing speed sensor on rear axle -G44-/-G46-

Note Removal and installation is described for the rear left speed sensor. Removal and installation of the rear right speed sensor is analogous. ...

Brake, brake mechanics

...

Other materials:

Removing and installing high-pressure pump
Removing Engine cold The fuel system is under high pressure.Risk of injury due to fuel which may spurt out.Release high pressure. → Chapter Risk of functional impairment due to soiling ...

Removing and installing parking brake motor -V282-/-V283-
Special tools and workshop equipment required Torque wrench -V.A.G 1331- Vehicle diagnostic tester Removing Note ...

Assembly overview - rear door trim
Note The assembly overview is shown for the rear door trim on driver side. The assembly overview for the front passenger side is analogous. 1 - Door trim Removing and installing → Chapter 2 - Rear d ...