Volkswagen Golf Service & Repair Manual: Removing and installing bracket for washer fluid reservoir, »R«

Removing

–	Remove washer fluid reservoir → Chapter.

–	Remove nuts -2-.

–	Remove bracket -1- from vehicle body.

–	Remove nuts -3-.

–	Unscrew bolt -5-, and remove bracket -4- from body.

Installing

Installation is carried out in the reverse sequence.

Specified torques

→ Chapter „Assembly overview – windscreen washer system, with headlight washer system, R“

Removing and installing bracket for washer fluid reservoir, »R«

Special tools and workshop equipment required Drip tray Removing – Remove front rig ...

Special tools and workshop equipment required Drip tray Note Dependent on the equipment level, the windsc ...

Lowering rear axle, multi-link suspension, four-wheel drive
Special tools and workshop equipment required Torque wrench -V.A.G 1332- Engine and gearbox jack -V.A.G 1383 A- ...

Removing and installing humidity sender for air conditioning system -G260-
The humidity sender for air conditioning system -G260- and the light/rain sensor -G397- form one component and are installed depending on vehicle equipment. – Removal and installation procedure is described in → E ...

Overview of fitting locations - components not located in passenger compartment, Golf Variant RHD
1 - Exhaust ventilation for passenger compartment Checking → Chapter Removing and installing → Chapter 2 - Fresh air intake Removing and installing → ...