| 1 - | Front cover |
| For electronics box in engine compartment |
| 2 - | Nut |
| Specified torque: 9 Nm |
| 3 - | Nut |
| Specified torque: 9 Nm |
| 4 - | Wire/line |
| For radiator fan(s) |
| Specified torque: 4.5 Nm |
| 5 - | Wire/line |
| For terminal 30 |
| Specified torque: 4.5 Nm |
| 6 - | Wire/line |
| For electromechanical power steering |
| Specified torque: 4.5 Nm |
| 7 - | Wire/line |
| For battery B+ |
| Specified torque: 6 Nm |
| 8 - | Wire/line |
| For terminal 30 |
| Specified torque: 4.5 Nm |
| 9 - | Wire/line |
| For alternator |
| Specified torque: 6 Nm |
| 10 - | Fuse holder A -SA- |
| Removing and installing → Chapter |
| 11 - | Fuse holder |
| Removing and installing → Chapter „Removing and installing fuse holder A -SA-“ |
| 12 - | Cover |
| For electronics box in engine compartment |
| 13 - | Relay and fuse holder B -SB- |
| With connecting bar for fuse holder A |
| Removing and installing → Chapter |
| 14 - | Wire/line |
| Specified torque: 6 Nm |
| 15 - | Bracket |
| For engine control unit |
| 16 - | Electronics box in engine compartment |
| Removing and installing → Chapter |
Relay carrier, fuse carrier in dash panel/A-pillar, LHD vehiclesRemoving and installing damper weight for refrigerant line, low-pressure
side
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331/- (5…50 Nm)
Removing
–
Observe safety precautions when working in the ...
Removing and installing curtain airbag with igniter, 2-door and 4-door
models
Special tools and workshop equipment
required
Release tool -VAS 1978/17- from release tool case -VAS
1978/35-
Removing
...
Notes on safety
Safety precautions during a road test
using test and measuring equipment
Observe the following if test and measuring equipment is
required during a road test:
Risk of accidents due to distraction and inadequate securing ...