Volkswagen Golf Service & Repair Manual: Overview of fitting locations – adaptive cruise control, variant 2
| 1 - |
Dash panel insert -KX2- |
| With control unit in dash panel insert -J285-. |
| Removing and installing
→ Chapter |
| Removing and installing
→ Chapter |
| 4 - |
Quick-release fastener |
| Serves as mounting bracket for Adaptive cruise control unit -J428- |
| With adjustment screws for adaptive cruise control unit -J428- |
| Measure adjustment and adjust if necessary
→ Fig. |
| 6 - |
Adaptive cruise control unit -J428- |
| Removing and installing
→ Chapter |
| 8 - |
Trim for radar sensor |
| 10 - |
Adaptive cruise control button -E357- |
| Integrated in multifunction steering wheel |
| Removing and installing
→ Communication; Rep. gr.91. |
1 -
Trim for radar sensor
2 -
Adaptive cruise control unit -J428-
Removing and installing
→ Chapter
...
Note
If the automatic distance control unit -J428- is renewed,
start the respective function → Vehicle
diagnostic tester.
...
Other materials:
Removing and installing Denso heat exchanger, RHD vehicles
Special tools and workshop equipment
required
Drip tray for workshop hoist -VAS 6208-
Hose clamps up to 25 mm -3094-
...
Rodent proofing
First read and observe the introductory information
and safety warnings Rodent proofing equipment is made up of special brushes
and casings and impedes entry to the engine compartment by rodents when the bonnet
is shut. This prevents damage caused to components by rodent bites.
NOTICE
If ...
Renewing front bonded rubber bush for lower suspension link
Special tools and workshop equipment required
Assembly tool -T10219-
Thrust plate -VW 402-
Press tool -VW 411-
Press tool -V ...
© 2016-2026 Copyright www.vwgolf.org
Overview of fitting locations – adaptive cruise control, variant 1
Removing and installing automatic distance control unit, variant 1