Volkswagen Golf Service & Repair Manual: Overview of fitting locations - components not located in passenger compartment, Golf RHD
| 1 - | Exhaust ventilation for passenger compartment |
| Checking → Chapter |
| Removing and installing → Chapter |
| 2 - | Fresh air intake |
| Removing and installing → Chapter |
| 3 - | Cover for fresh air intake duct |
| Removing and installing → Chapter |
| 4 - | Ambient temperature sensor -G17- |
| Removing and installing → Chapter |
Overview of fitting locations - components not located in passenger
compartment, Golf LHD
1 -
Exhaust ventilation for passenger compartment
Checking
→ Chapter
Removing and installing
→ Chapter
...
Overview of fitting locations - components not located in passenger
compartment, Golf Variant LHD
1 -
Exhaust ventilation for passenger compartment
Checking
→ Chapter
Removing and installing
→ Chapter
...
Other materials:
Separating control unit from hydraulic unit
Special tools and workshop equipment
required
ESD workplace -VAS 6613-
Torx bit T25
If a control unit is defective, separate it from the
hydraulic unit and renew only the control ...
Assembly overview - toothed belt, engine codes CPTA, CHPA, CZEA, CZDA
1 -
Toothed belt
Before removing, mark direction of rotation with chalk or
felt-tipped marker pen.
Check for wear
Removing
→ Chapter
Installing (adjusting valve timing), CPTA, CZEA
& ...
Overview of fitting locations – controls in centre console
Note
The illustration shows fitting locations for LHD vehicles. Fitting
locations for RHD vehicles are similar.
1 -
Starter button -E378-
Removing and installing
→ Chapter
2 -
Switch mod ...
