This chapter contains information on the following subjects:
→ Opening or closing the electric panorama sliding/tilting roof
→ Function of the electric panorama sliding/tilting roof→ The roll-back function for the electric panorama sliding/tilting roof
Additional information and warnings:

WARNING

NOTICE
Leaves and other loose items must be removed from the guide rails of the electric panorama sliding/tilting roof at regular intervals, either by hand or using a vacuum cleaner.
If there is a fault in the electric panorama sliding/tilting roof, the roll-back function will not work properly. Proceed to a qualified workshop.
Opening or closing the electric panorama sliding/tilting roofConicity
Conicity is caused by a slight offset of the tread and/or
the belt (amounting to a few tenths of a millimetre) relative to
the geometric centre of the tyre. Taper is not visible and
cannot be measured with equipment available in the workshop.
& ...
Sockets in the vehicle
Fig. 125 In the rear section of the centre
console: 12-volt socket
Fig. 126 In the luggage compartment: 12-volt
socket
First read and observe the introductory information
and safety warnings Maximum power rating
Electrical socket
Maximum power rating
...
Renewing bonded rubber bush for wheel bearing housing, four-wheel drive
Special tools and workshop equipment required
Assembly tool -3301-
Viscous fan fitting tool -3367-
Carrier -3390-
Torque wrench -V.A.G 1332-
Removing
– ...