Volkswagen Golf Service & Repair Manual: Removing and installing bracket for roof grab handle

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Interion equipment / Equipment / Removing and installing bracket for roof grab handle

Note

Removal and installation is described for the left front bracket for roof grab handle. Follow same instructions for the remaining brackets for roof grab handle as appropriate.

Special tools and workshop equipment required

Torque wrench -V.A.G 1783

Removing

–	Remove moulded headliner → Chapter.

–	If fitted, unclip cable guide -1- from bracket for roof grab handle -3-.

–	Unscrew bolts -2- and remove bracket for roof grab handle -3-.

Installing

Note

Before installing, check all fasteners for damage and renew if necessary.

Installation is carried out in reverse order.

Specified torques

→ Chapter „Assembly overview - roof grab handle“

Removing and installing sun visor centre mount

Note Removal and installation is described for the sun visor centre mount on the driver side. Follow same instructions for the front passenger side as ...

Centre console

...

Other materials:

Assembly overview - tank flap unit
1 - Fuel tank flap – Removing and installing → Chapter. 2 - Tank flap unit Removing and installing → Chapter 3 - Water drain hose Routed between wheel ...

Fitting locations overview - mobile online services, eGolf
1 - Control unit in dash panel insert -J285- 2 - Telephone microphone -R38- Installed in front section of roof console Removing and installing → Chapter 3 - Radio/RNS -RX ...

Moving push button to installation position in the handle
Special tools and workshop equipment required Release tool -T10534- If the push-button was pressed by mistake, the installation position can be restored. ...