First read and observe the introductory information
and safety warnings
| Lit up | Possible cause | Solution |
|---|---|---|
|
Partial or complete fault in the vehicle lightinga), excluding bend lighting. b) | Change the corresponding bulb or If all bulbs are functioning, go to a qualified workshop. |
|
The rear fog light is switched on. | . |
|
The fog light is switched on. | |
|
Turn signal for the right or left. The indicator lamp will flash twice as fast if one of the turn signals on the vehicle or trailer is not working. |
If necessary, check the vehicle lights and the trailer lights. |
|
Trailer turn signal. The indicator lamp goes out if a trailer turn signal or all trailer lights stop working. |
Check the trailer lighting as required. |
|
Main beam is switched on or the headlight flasher is being operated. | . |
|
Main beam assist switched on. | . |
Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.

WARNING

NOTICE
a) A separate display appears in the instrument cluster if there is a bend lighting fault.
b) Displayed in colour on an instrument cluster with colour display.
Introduction
Turn signal and main beam leverCharging battery with battery charger -VAS 5906-
WARNING
Danger of injury! Observe warning notices and safety
regulations
→ Chapter!
WARNING
It is not permissible ...
Dimensions – lettering on rear lid, “R-Line”
Note
When fitting the lettering, observe the fitting notes
→ Anchor.
1 -
Lettering
Model designation
2 -
Height dimension
73 ± 1 mm, from upper edge of lettering to tail light.
...
Installing dual clutch
Special tools and workshop equipment
required
Support device -T10323-
-T10356/5- from assembly tool -T10356-
&nb ...