This chapter contains information on the following subjects:
→ Indicator lamps
→ Turn signal and main beam lever→ Switching lights on and off
→ Lights and vision – functions→ Main beam assist
→ Switching over headlights for driving abroad (travel mode)→ Coming Home and Leaving Home functions (orientation lighting)
→ Headlight range control, instrument and switch lighting→ Interior and reading lights
Observe any country-specific regulations when using vehicle lighting.
The driver is responsible for the correct headlight position and the correct headlight setting.
Additional information and warnings:

WARNING

WARNING
Lights
Indicator lampsRemoving and installing lower suspension link, vehicle with manual gearbox
or dual clutch gearbox 0CW
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Removing
–
Loosen wheel bolts.
–
...
Dimensions – lettering on rear lid, “R-Line”
Note
When fitting the lettering, observe the fitting notes
→ Anchor.
1 -
Lettering
Model designation
2 -
Height dimension
73 ± 1 mm, from upper edge of lettering to tail light.
...
Overview of fitting locations - front control motors, air conditioning
system with electric/manual controls, LHD vehicles
1 -
Temperature flap control motor -V68-
With potentiometer for temperature flap control motor -G92-.
Checking: with vehicle diagnostic tester
Removing and installing
→ Chapter.
Renewing: in ...