Volkswagen Golf Service & Repair Manual: Electronically controlled damping system
- Assembly overview - electronically controlled damping system, torsion beam axle, saloon
- Assembly overview - electronically controlled damping system, multi-link suspension, saloon
- Removing and installing electronically controlled damping control unit -J250-, saloon
- Removing and installing front body acceleration senders -G341-/-G342-
- Removing and installing rear body acceleration sender -G343-
Assembly overview - electronically controlled damping system, torsion beam
axle, saloon
1 -
Front right vehicle lever sender -G289-
Removing and installing
→ Chapter
2 -
Front right body acceleration se ...
Other materials:
Contact corrosion
Contact corrosion can occur if unsuitable fasteners (bolts,
nuts, washers, etc.) are used.
Therefore, only fastening elements with a special surface
coating are installed in the vehicle.
In addition, rubber and plastic p ...
Removing and installing refrigerant shut-off valve for heater and air
conditioner unit -N541
Removing
–
Observe safety precautions
→ Chapter „Safety precautions when handling refrigerants“.
–
Comply with notes
→ Chapter „Working on refrigerant circuit“.
...
Safety precautions when working in the vicinity of high-voltage components
Danger to life due to high voltage
The high-voltage system is under high voltage. If high-voltage
components are damaged, there is a risk of severe or fatal injury due to
electric shock.
–
Perform visual check of high-voltage components and high-v ...
